+6 016-832 3092

borneopaints@gmail.com
Get a Quote
Get a Quote
Borneo Paints Water Block
Add to Quote

Borneo Paints Water Block

Gloss Enamel Paint (Standard Colour/ Tint Base)
SKU: BP-WB Category:

BORNEO WATER BLOCK is a professional grade, low VOC water-based formulation which is specially engineered to deeply penetrate and shield the microscopic pores of the surfaces. Borneo Water Block contains the nano particles which impregnate the substrate and react chemically and bond strongly with the substrate which produces durable hydrophobic treatment.

BORNEO WATER BLOCK repels water and salts and yet remains highly permeable, allowing moisture to escape from many absorbent mineral substrates, such as bricks (including vertical and horizontal concrete), sand-lime brick, natural sandstone and mineral plaster. Borneo Water Block also provides excellent resistance to mould, mildew and fungus.

Surface Preparation

The application surface must be clean and free from any grease. Wash the fungus and algae affected area. Apply BORNEO WATER BLOCK by using brush or the pipette. No dilution is required. On very absorptive surfaces, re-apply within 3 hours.

Application Data

Properties : Milky white water emulsion. Does not change the appearance of the surface applied. The product must not freeze. Can be stored in its original, sealed container for 24 months after production date.

Mixing : Replace 1/3 of water used in your mix with Borneo Water Block. Mix Well. In any case (surface application or mixing) test result in a small area before full scale application.

Safety : Borneo Water Block is a non hazardous product but as a precaution avoid contact with skin or eyes and wear protective gloves and goggles. Dispose this material properly. Keep out of the reach of children. In case of contact with eye and skin, rinse immediately with plenty of water and seek medical advice.

Always request, read and comprehend the Safety Data Sheet of the product before application.

Directions for Use

Flooding is the preferred way to achieve maximum water repellency. Two “wet on wet” coats are needed to ensure complete coverage. Maximum water repellency is achieved 24 hours post application. If it starts to rain, stop treatment and cover the impregnated areas.

Consumption : 8-9m² / L. Dependant of substrate properties.

Download Product Data Sheet

  • No Need Hacking

  • 5 Years Protection

You May Also Like

Find latest trends with the newest additions